Action
3 Use the green handle to open and hold the Z-
sensor unit.
4 1. Take a cleaning cloth and move the cloth
three times over the lower sensors.
2. Take a new cleaning cloth and move the
cloth three times over the upper sensors.
5 Gently close the Z-sensor unit.
6 1. Hold the paper guide with one hand and
turn the knob to unlock the guide with the
other hand.
2. Lower the paper guide until the guide is
locked.
7 Close the front door of the registration output module.
After you finish
Dispose the used cleaning cloths.
Clean the Z-sensors in the registration output module without system tray
366
Chapter 13 - Maintain the printer
To Next Page
Loading...
