Action
3 Pull one leaf spring towards the
front side and at the same time
push the other leaf spring towards
the back side to open the SZ-unit.
4 1. Moisten a cleaning cloth with
PML.
2. Use the cloth to moisten the
upper and lower rollers.
Turn the rollers to moisten the
complete surface.
5 1. Wait for about 10 seconds to
let the rollers absorb the PML.
2. Clean the upper and lower
pair of rollers. Rub the moist
cloth across the rollers from
the side until all pollution is
gone.
Turn the rollers to clean the
complete surface.
NOTE
The color of the roller
can change but this can-
not damage the printer.
4
Clean the SZ-rollers in the paper path module
Chapter 13 - Maintain the printer
371
To Next Page
Loading...
Need help?
General