Action
3 Push the leaf springs outward at
the front and rear side to open the
SZ-unit.
4 Moisten a cleaning cloth with PML
and moisten the upper and lower
rollers with the cloth.
5 • Wait for about 10 seconds to let
the PML absorb. Clean the up-
per and lower pair of rollers
with the wet cloth until the pol-
lution is gone.
• Rub across the rollers from the
side, and turn the rollers to
clean the complete surface.
NOTE
A discoloration of the
rollers can occur but is
not harmful.
6 Push firmly against the middle of
the unit to close the SZ-unit. Make
sure the unit is also locked at the
rear side.
4
Clean the SZ-rollers in the registration output module without system tray
Chapter 13 - Maintain the printer
383
To Next Page
Loading...
