Action
7 Slowly turn the knob clockwise until the side
sliders touch the stack without damaging it.
8 Squeeze the green handle of the front slider to
move the trailer-edge sliders carefully against
the stack without damaging it.
9 Take the next stack of media. Do not load more
than 500 sheets (80 g/m² / 20 lb bond) at the
same time. (
Unpack the media
on page 92)
Paper trays 1 and 2 can hold one ream (approxi-
mately 500 sheets (80 g/m² / 20 lb bond)). Paper
trays 3 and 4 can hold three reams.
Carefully put the new stack on the already loa-
ded stack without adjusting the sliders.
10
IMPORTANT
Ensure that the loaded media stack does not exceed the loading limit mark on the
back slider.
Then the loaded media stack is maximum 63 mm / 2.48" (paper trays 1 and 2) or
181 mm / 7.13" (paper trays 3 and 4).
11 Gently push the paper tray back until it clicks in-
to place.
Load media into the paper module
96
Chapter 6 - Job media handling
To Next Page
Loading...
Need help?
General