Software Version C
- 107 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
Fig. 108 Zero point setting
5. Save the setting. The SYSTEM SETTINGS menu appears.
Note!
• When you set MANUALLY to NO, the "Set zero point with Remote In only"
or the "Zero point locked" message appears in the MAINTENANCE
menu!
• When you set REMOTE to NO, no message appears in the
MAINTENANCE menu.
• For more information on setting the zero point via the external control
system, read chapter 9.12.1, page 164.
SYSTEM SETTINGS
ZERO POINT HAS BEEN SET:
MANUALLY: YES
REMOTE: YES
REJECT P01 SAVE
To Next Page
