Software Version C
- 74 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
9.5.5.1 Offset + slope - define set name
With this function, you can change the preset names of the offset and slope sets
SUF01 - SUF08 to a name of your choice. To do this, you can use 12 characters
maximum.
1. Select the DEFINE NAME menu item in the OFFSET + SLOPE menu and
press [ENTER].
2. The character field appears.
Fig. 66 Define offset + slope set name
3. Enter a new name via the character field (see chapter 9.2, page 37).
4. Select OK and press [ENTER]. The character field is closed. The OFFSET
menu item is marked.
5. Save the new name of the offset + slope set.
OFFSET + SLOPE SUF01
DEFINE NAME:
SUF01
ABCDEFGHIJKLMNOPQ
RSTUVWXYZ ()
+ - / *0123456789 .%
OFFSET
<<< >>> DEL OK
SLOPE
REJECT P02 SAVE
To Next Page
