Software Version C
- 41 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
9.2.2 Information on the measuring mode
The measuring system normally is in the measuring mode, updating the four
measuring results for the current product every 1.0 seconds.
This measuring mode runs automatically in the MAIN MENU, the language
selection and in the three menus MEASUREMENT DISPLAY, DATA LOGGER
DISPLAY, SYSTEM INFORMATION DISPLAY.
The measuring mode is interrupted for three seconds for manual or Remote In
product change.
The measuring mode is switched off during product configuration, system
settings or maintenance. Measuring mode is restarted upon return to the main
menu.
In the measuring mode, the data logger is periodically updated with the four
measuring results. When the measuring mode is switched off, the data logger
records "Hold" or "No Data"; the mA-outputs continue displaying the last valid
results. This way, it is always guaranteed that the data of the measurement
display and the data logger in the converter is consistent with the mA-output as
well as with external data recording.
To Next Page
