Faults
- 188 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
10 Faults
Among other possibilities, you can detect faults whenever an error message on
the converter appears. Try to clear the fault using the following table and the
instructions given in the chapter "Software" in the instruction manual of the
converter. Should you have any difficulty clearing the fault, feel free to contact
our customer service. To solve the problem efficiently, we ask you to have the
sheet with system data of your sensor or system at hand.
See preliminary note for our contact data.
To Next Page
