Optek C4101 - System Settings - Ma-Inputs

Software Version C
- 50 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
9.4.5 System settings - mA-inputs
This menu only applies to converters C4121, C4221, C4222, C4322, and
C4422.
In this menu you can select the mA-inputs (clamps 21-24) you want to connect.
1. Select SYSTEM SETTINGS from the main menu and press [ENTER].
2. Select mA INPUTS and press [ENTER].
Fig. 41 Menu system settings, choosing mA-inputs
3. The cursor is located in the menu item mA INPUT 1. Press [ENTER], select
YES or NO and press [ENTER] again.
4. The cursor is located in the menu item mA INPUT 2.
Press [ENTER], select YES or NO, and press [ENTER] again.
5. Save the entry. The SYSTEM SETTINGS menu appears.
Fig. 42 Choosing condition of mA-inputs
SYSTEM SETTINGS
FAILSAFE
PASSWORD PROTECTION
OPTEK INPUTS
mA INPUTS
SYSTEM DATA SENSOR 1
SYSTEM DATA SENSOR 2
SYSTEM DATA SENSOR 3
SYSTEM DATA SENSOR 4
20:05:2006 P01 11:26:55
SYSTEM SETTINGS
THESE mA INPUTS ARE
CONNECTED:
mA INPUT 1: YES
mA INPUT 2: NO
(4 - 20 mA REPRESENT 0 - 100 %)
REJECT P01 SAVE