Software Version C
- 181 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
When the number of sensors at the lamp output is set to E = 2, error message
no. 1003 pops up upon first lamp failure, error message no. 1005 upon second
lamp failure!
When the number of sensors at the lamp output is set to F = 2, error message
no. 1004 pops up upon first lamp failure, error message no. 1006 upon second
lamp failure!
9.14.3 Communication error
The converter pops up messages for internal communication errors in all menus.
They provide precise instructions for rapid troubleshooting.
The system displays "No communication" between main computer and the
second input card MA-11.
There are 5 error messages for the five individual plugs at the converter.
Error messages regarding internal communication trigger a system alarm (relay)
and cause the system LED (5) to flash red. In case of a permanent error, the
converter repeats the error message within one minute.
Error messages regarding internal communication have top priority and can
overlap other error messages!
Deactivate the error message by pressing [CLEAR]. The converter returns to
measuring mode.
Fig. 188 Error message "No communication..."
20:05:2006 P01 11:26:55
M01
M02
0.00 5.00
0.00 5.00
SIGNAL LOSS
A
1.56 CU
M03
0.00 5.00
2.47 CU
M04
0.00 5.00
SIGNAL LOSS
B+D+MA1
NO COMMUNICATION WITH
1102
CARD ADDRESS 2
To Next Page
