Safety
- 5 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
3Safety
3.1 General safety instructions
Only operate the converter when free from defects and in accordance with the
instructions provided in this manual.
Read this instruction manual prior to initial commissioning. This applies
especially to persons only operating the converter occasionally, such as
maintenance staff.
Observe all safety and information labels on the product and keep them in
readable condition.
Inspect the product for signs of physical damage. Report any damage
immediately and do not commission the product until corrective actions have
been taken.
Protect the converter from impacts causing corrosion or preventing components
from working properly.
Have faulty parts of the measuring system replaced immediately.
Spare parts must comply with the technical requirements defined by optek. This
is always guaranteed when using original spare parts.
For maintenance and repair activities, attach a warning sign to the external
release device to prevent re-commissioning of the converter.
When malfunctioning, take the product out of operation. Repair the malfunctions
immediately by a qualified electrician.
The safety instructions are to be supplemented with the current national
regulations on accident prevention.
To Next Page
