Optek C4101 - Control Via an External Control System (Remote); Input Signals from Control System - Remote in; Remote in Monitor

Software Version C
- 164 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
9.12 Control via an external control system (Remote)
Converters C4121, C4221, C4222, C4322 and C4422 can be controlled via an
external control system.
9.12.1 Input signals from control system - Remote In
24 V DC control cables connected to the applicable remote input clamps are
used to activate different converter functions:
• PRODUCT CHANGE
• SYSTEM ZERO POINT
•HOLD
It is required to have the corresponding remote functions enabled in the system
settings. See the following chapters to enable the remote functions:
• SYSTEM ZERO POINT chapter 9.10.6, page 106
• PRODUCT CHANGE chapter 9.10.7, page 108
• HOLD chapter 9.10.12, page 119
For more information on the Remote In 1 and 2 functions, read
chapter 9.10.11, page 117.
9.12.1.1 Remote In Monitor
With this function, you can display logical states of the control inputs "Remote
In", and check the wiring at the "Remote In" inputs.
1. Select the SERVICE menu item in the MAINTENANCE menu and press
[ENTER].
2. Select the MONITORS menu item in the SERVICE menu and press
[ENTER].
3. Select the REMOTE IN MONITOR function in the MONITORS menu and
press [ENTER].
Fig. 180 Menu service, choosing Remote In Monitor
MONITORS
LAMP MONITOR
DETECTOR MONITOR
MEASURING RESULT MONITOR
mA MONITOR
RELAY + LED MONITOR
REMOTE IN MONITOR
SUBASSEMBLY MONITOR
20:05:2006 P01 11:26:55