Software Version C
- 49 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
5. Select CHANNEL B and press [ENTER]. Select YES or NO and press
[ENTER]. When connecting one single channel sensor or one dual channel
sensor, select NO.
6. Press [ENTER] again.
7. Select CHANNEL C and press [ENTER]. Select YES or NO. Select NO for
one single channel sensor. Select YES for one dual channel sensor.
8. Press [ENTER] again.
9. Select CHANNEL D and press [ENTER]. Select YES or NO. When
connecting one single channel sensor or one dual channel sensor, select
NO.
10. Press [ENTER] again.
11. Save the entry. The SYSTEM SETTINGS menu appears.
Fig. 40 Choosing optek inputs
SYSTEM SETTINGS
THESE DETECTOR INPUTS ARE CONNECTED:
CHANNEL A: YES
CHANNEL B: NO
CHANNEL C: NO
CHANNEL D: NO
REJECT P01 SAVE
To Next Page
