Software Version C
- 160 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
Note!
• If the internal system communication is erroneous, information on one or
several addresses can be missing.
• If a check mark at the end of a line is missing, the system has detected
missing or questionable calibration data in this subassembly.
• When the circuit cards are changed, error message 1021 "Inconsistency
in configuration" appears. Enter the SUBASSEMBLY MONITOR menu
and save the configuration with [ENTER].
To Next Page
