Software Version C
- 185 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
If errors occur during saving of entries or settings, only one error number is
displayed in the error message field. You must repeat your entry. If a saving
error occurs several times, a hardware failure has probably occurred on board
MC-02. In this case, please contact our customer service.
The following table contains rare error messages which pop up during saving.
Tab. 24 Error messages during saving
No. Error message Caused by errors during saving of:
1201 ERROR 1201 Display - contrast, brightness, compensation
1202 ERROR 1202 Format date & time
1203 ERROR 1203 Data logger time interval
1204 ERROR 1204 Damping
1205 ERROR 1205 Lamp voltage E
1206 ERROR 1206 Lamp voltage F
1207 ERROR 1207 Number of sensors
1208 ERROR 1208 Zero point remote / manually
1209 ERROR 1209 Active product after product change
1210 ERROR 1210 mA-outputs 0-20 / 4-20
1211 ERROR 1211 Relay 1-3 limit values / remote
1212 ERROR 1212 Remote In
1213 ERROR 1213 Hold
1214 ERROR 1214 Failsafe (-10 % / +110 %)
1215 ERROR 1215 Password name
1216 ERROR 1216 Password allocation
1217 ERROR 1217 Password duration
1218 ERROR 1218 optek inputs
1219 ERROR 1219 mA-inputs (assignment)
1220 ERROR 1220 Sensor data
1221 ERROR 1221 TF sensor data
1230 ERROR 1230 Measuring range data
1231 ERROR 1231 Limit values data
1232 ERROR 1232 Display format
1233 ERROR 1233 Product name
1234 ERROR 1234 Linearization
1235 ERROR 1235 Active product
1236 ERROR 1236 Offset + slope set
1240 ERROR 1240 Sensor adaptation
1250 ERROR 1250 Zero point data
1251 ERROR 1251 Configuration
To Next Page
