Optek C4101 - Page 70

Software Version C
- 62 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
* This function selection only applies to converter with mA inputs.
Note!
Sensor AF16 can be replaced by probe AS16 (not EX).
You can connect two probes AS56 to each lamp output. Before doing so, you
must configure the lamp output for two sensors in the SYSTEM SETTINGS \
LAMP VOLTAGE menu.
Measuring functions
4 - 20 mA
The 4 - 20 mA (1) and 4 - 20 mA (2) measuring functions may be scaled directly
in correspondence with transmitter settings.
Zero point setting for these two functions has to be carried out externally!
C4422
C4452
AF46 A C B D ABS -CU (A)
ABS -CU (C)
ABS -CU (B)
ABS -CU (D)
ABS -CU (A-C)
ABS -CU (B-D)
A-CU (A-C)-(B-D)
% TRANSM (A)
% TRANSM (C)
% TRANSM (B)
% TRANSM (D)
% TRANSM (A/C)
% TRANSM (B/D)
% TR (A/C)/(B/D)
PROD-FEEDBACK
4 - 20 mA (1)*
4 - 20 mA (2)*
Tab. 7 Measuring functions for evaluating detector signals (cont.)
Converter
SENSOR 1
(LAMP E)
SENSOR 2
(LAMP F)
SENSOR 1
connected to:
SENSOR 2
connected to:
Admissible
function selection
Meas. Ref. Meas. Ref.