Software Version C
- 72 -
optek-converter C4101 Version 07.2009_1.2US, 23.07.2009
www.optek.com
5. Type in the correct values via the numerical keyboard and press [ENTER].
6. If you do not wish to enter all 11 value pairs, end this process by pressing
[ENTER] twice in an empty line.
7. To delete a value pair, select the desired line with the arrow keys
or ,
press [CLEAR], then [ENTER] and then [CLEAR] and [ENTER] again. The
software deletes the selected value pair, sorts the linearization table again
and calculates the new linearization.
8. Save the new settings.
The linearization table can later be specified in some areas. To do this, it is not
necessary to enter all points again. Only supplementary value pairs are entered.
To Next Page
