_____________________________________________________________________________
LB9 User’s Guide 1205/1523
Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree.
The port role will be one of the following values: Root Port, Designated Port, Alternate Port, Backup
Port, Master Port, or Disabled Port.
Designated Root - Root Bridge for the selected MST instance. It is made up using the bridge priority
and the base MAC address of the bridge.
Designated Cost - Path Cost offered to the LAN by the Designated Port.
Designated Bridge - Bridge Identifier of the bridge with the Designated Port. It is made up using the
bridge priority and the base MAC address of the bridge.
Designated Port - Port Identifier on the Designated Bridge that offers the lowest cost to the LAN. It
is made up from the port priority and the interface number of the port.
Loop Inconsistent State - This parameter identifies whether the port is in loop inconsistent state.
Transitions Into Loop Inconsistent State - The number of times this interface has transitioned into
loop inconsistent state.
Transitions Out Of Loop Inconsistent State - The number of times this interface has transitioned
out of loop inconsistent state.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will
not be retained across a power cycle unless a save configuration is performed.
Refresh - Refresh the screen with most recent data.
To Next Page
Loading...
Need help?
General