Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 125/1523
6.2.6.9 set igmp groupmembership-interval
The user can go to the CLI VLAN Configuration Mode to set the IGMP Group Membership Interval time
on a particular VLAN, use the set igmpgroupmembership-interval <vlan-id> <2-3600> vlan
configuration command. Use the no set igmp groupmembership-interval <vlan-id> return to default
value 260.
set igmp groupmembership-interval <vlan-id> <2-3600>
no set igmp groupmembership-interval <vlan-id>
<vlan-id> - VLAN ID (Range: 1 – 4093).
<2-3600> - The range of group membership interval time is 2 to 3600 seconds.
Default Setting
260
Command Mode
VLAN database
6.2.6.10 set igmp maxresponse
The user can go to the CLI Interface VLAN database Mode to set the IGMP Maximum Response time on
a particular VLAN, use the set igmp maxresponse <vlan-id> <1-25> vlan configuration command. Use
the no set igmp maxresponse <vlan-id> return to default value 10
set igmp maxresponse <vlan-id> <1-25>
no set igmp maxresponse <vlan-id>
<vlan-id> - VLAN ID (Range: 1 – 4093).
<1-25> - This value must be less than the IGMP Query Interval time value. The range is 1 to 25
seconds.
Default Setting
10
Command Mode
VLAN database
To Next Page
Loading...
Need help?
General