Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 146/1523
6.2.8.11 ipv6 mld snooping mcrtrexpiretime
The user can go to the CLI Interface Global/Interface Configuration Mode to set the Multicast Router
Present Expiration time for the system or on a particular interface, use the ipv6 mld snooping
mcrtrexpiretime <0-3600> global/interface configuration command. Use the no ipv6 mld snooping
mcrtrexpiretime to return to default value 0.
ipv6 mld snooping mcrtrexpiretime <0-3600>
no ipv6 mld snooping mcrtrexpiretime
<0-3600> - The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no
expiration.
Default Setting
0
Command Mode
Global Config
Interface Config
6.2.8.12 ipv6 mld snooping mrouter interface
The user can go to the CLI Interface Configuration Mode to configure the interface as a multicast
router-attached interface or configure the VLAN ID for the VLAN that has the multicast router attached
mode enabled, use the ipv6 mld snooping mrouter {interface | <vlan-id>} interface configuration
command. Use the no ipv6 mld snooping mrouter {interface | <vlan-id>} disable multicast router
attached mode for the interface or a VLAN.
ipv6 mld snooping mrouter {interface |<vlan-id>}
no ipv6 mld snooping mrouter {interface|<vlan-id>}
<vlan-id> - VLAN ID (Range: 1 – 4093).
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General