Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 179/1523
6.2.11.8 switchport unicast rate
This command will protect your network from unicast storms by setting a threshold level for unicast traffic
on each port.
switchport unicast rate <1-14880000>
<1-14880000> - Specify the threshold for unicast traffic
Note: pps (packet per second)
Default Setting
4160 for 10G interfaces
512 for 1G interfacces
Command Mode
Interface Config
This command will protect your network from unicast storms by setting a threshold level for unicast traffic
on all ports.
switchport unicast all rate <1-14880000>
<1-14880000> - Specify the threshold for unicast traffic.
all - This command represents all interfaces.
Note: pps (packet per second)
Default Setting
4160 for 10G interfaces
512 for 1G interfaces
Command Mode
Global Config
To Next Page
Loading...