_____________________________________________________________________________
LB9 User’s Guide 269/1523
6.3.16.2.2 absolute
Use this command to add an absolute time entry to a time range. Only one absolute time entry is allowed
per time-range. The time parameter is based on the currently configured time zone.
The [start time date] parameters indicate the time and date at which the configuration that referenced
the time range starts going into effect. The time is expressed in a 24-hour clock, in the form of
hours:minutes. For example, 8:00 is 8:00 am and 20:00 is 8:00 pm. The date is expressed in the format
day month year. If no start time and date are specified, the configuration statement is in effect
immediately.
The [end time date] parameters indicate the time and date at which the configuration that referenced
the time range is no longer in effect. The end time and date must be after the start time and date. If no
end time and date are specified, the configuration statement is in effect indefinitely.
To Next Page
Loading...
Need help?
General