Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 291/1523
This command specifies that this port is an Edge Port within the common and internal spanning tree.
This will allow this port to transition to Forwarding State without delay.
spanning-tree edgeport
no spanning-tree edgeport
no - This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Default Setting
None
Command Mode
Interface Config
This command sets the Edgeport BPDU Filter enable/disable parameter for sending/receiving BPDUs
on this switch. This command only works on dot1d mode.
spanning-tree edgeport bpdufilter
no spanning-tree edgeport bpdufilter
no - This command sets the Edgeport BPDU Filter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Global Config
To Next Page
Loading...