Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 359/1523
6.8.3.3 dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
dot1x system-auth-control [monitor]
no dot1x system-auth-control [monitor]
no - This command is used to disable the dot1x authentication support on the switch.
Default Setting
Disabled
Command Mode
Global Config
6.8.3.4 dot1x user
This command adds the specified user to the list of users with access to the specified port or all ports.
The <username> parameter must be a configured user.
dot1x user <user> {<slot/port> | all}
no dot1x user <user> {<slot/port> | all}
<user> - Is the login user name.
<slot/port> - Is the desired interface number.
all - All interfaces.
no - This command removes the user from the list of users with access to the specified port or all
ports.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
Need help?
General