Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 360/1523
6.8.3.5 dot1x guest vlan
This command configures the Guest VLAN capability on the interface. The command specifies an active
VLAN as an IEEE 802.1x guest VLAN.
dot1x guest- vlan <vlan-id>
no dot1x guest-vlan
no - This command disables the Guest VLAN capability on this interface.
Default Setting
Disabled
Command Mode
Interface Config
6.8.3.6 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <1-10> value must
be in the range 1 - 10.
dot1x max-req <1-10>
no dot1x max-req
<1-10> - maximum number of times (Range: 1 – 10).
no - This command sets the maximum number of times the authenticator state machine on this port
will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant to the default
value, that is, 2.
Default Setting
2
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General