_____________________________________________________________________________
LB9 User’s Guide 407/1523
6.8.4.80 radius server dead-time
This command cnfiguresradius server dead time.
minutes - Set radius server dead time (sec). Range 0 - 2000.
no - This command is used to set dead time to the default value.
Default Setting
0
Command Mode
Global Config
6.8.4.81 radius server host
This command is used to configure the RADIUS authentication and accounting server.
If the 'auth' token is used, the command configures the IP address to use to connect to a RADIUS
authentication server. Up to 3 servers can be configured per RADIUS client. If the maximum number of
configured servers is reached, the command will fail until one of the servers is removed by executing the
no form of the command. If the optional <port> parameter is used, the command will configure the UDP
port number to use to connect to the configured RADIUS server. In order to configure the UDP port
number, the IP address must match that of a previously configured RADIUS authentication server. The
port number must lie between 1 - 65535, with 1812 being the default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS accounting
server. Only a single accounting server can be configured. If an accounting server is currently
configured, it must be removed from the configuration using the no form of the command before this
command succeeds. If the optional <port> parameter is used, the command will configure the UDP port
to use to connect to the RADIUS accounting server. The IP address specified must match that of a
previously configured accounting server. If a port is already configured for the accounting server then the
new port will replace the previously configured value. The port must be a value in the range 1 - 65535,
with 1813 being the default value.
To Next Page
Loading...
Need help?
General