Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 449/1523
6.10.2.7 sntp server
This command configures an SNTP server (with a maximum of three) where the server address can be
an ip address or a domain name and the address type either IPv4, IPv6, dnsv6 or dns. The optional
priority can be a value of 1-3, the version is a value of 1-4, and the port id is a value of 1-65535.
sntp server <ipaddress
/ipv6address/dom
ain-nam
e> <addresst
ype> [<1-3> [<
version> [<portid>]]]
no sntp server remove <ipaddress/ipv6address/domain-name>
<ipaddress/ipv6address/domain-name > - IPv4 or IPv6 address or domain name of the SNTP
server.
<addresstype > - The address type is ipv4 or ipv6 or dns or dnsv6.
<1-3> - The range is 1 to 3.
<version> - The range is 1 to 4.
<portid> - The range is 1 to 65535.
no - This command deletes an server from the configured SNTP servers.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
Need help?
General