Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 450/1523
6.10.2.8 sntp clock timezone
This command sets the time zone for the switch’s internal clock.
sntp clock timezone <name> <0-12> <0-59> {before-utc | after-utc}
<name> - Name of the time zone, usually an acronym. (Range: 1-15 characters)
<0-12> - Number of hours before/after UTC. (Range: 0-12 hours)
<0-59> - Number of minutes before/after UTC. (Range: 0-59 minutes)
before-utc - Sets the local time zone before (east) of UTC.
after-utc - Sets the local time zone after (west) of UTC.
Default Setting
Taipei 08:00 After UTC
Command Mode
Global Config
6.10.2.9 sntp multicast client poll-internal
This command will set the poll interval for SNTP multicast clients in seconds.
sntp multicast client po
ll-interva
l <poll-inter
val>
no sntp multicast client poll-interval
<poll-interval> - Polling interval. It’s 2^(value) seconds where the range of value is 6 to 10.
no – This command will reset the poll interval for SNTP multicast client to its default value.
Default Setting
The default value is 6.
Command Mode
Global Config
To Next Page
Loading...
Need help?
General