To Next Page

To Previous Page

UANTA COMPUTER INC.

Layer 2/3/4 Managed Switch

_____________________________________________________________________________

LB9 User’s Guide 451/1523

6.10.2.10 sntp source-interface

Use this command to specify the physical or logical interface to use as the SNTP client source interface.

If configured, the address of source interface is used for all SNTP communications between the SNTP

server and the SNTP client. Otherwise, there is no change in behavior. If the configured interface is

down, the SNTP client falls back to its default behavior.

Syntax

sntp source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan <vlan-id>}

no sntp source-interface

<slot/port> - Specifies the port to use as the source interface.

<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the

loopback ID is 0 to 7.

<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel

ID is 0 to 7.

<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of the VLAN ID is

1 to 4093.

no - This command will reset the SNTP source interface to its default settings.

Default Setting

None

Command Mode

Global Config

Quanta Computer T5016-LB8D User Manual

Questions and Answers: