_____________________________________________________________________________
LB9 User’s Guide 470/1523
6.12.1.12 show lldp med remote-device detail
The user can go to the CLI Privilege Exec to d display detailed information about remote devices that
transmit current LLDP-MED data to an interface on the system, use the show lldp med remote-device
detail <slot/port> Privilege command.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Term Definition:
Capabilities: Specifies the supported and enabled capabilities that was received in MED TLV on
this port.
MED Capabilities Supported: Specifies supported capabilities that was received in MED TLV
on this port.
MED Capabilities Enabled: Specifies enabled capabilities that was received in MED TLV on
this port.
Device Class: Specifies device class as advertised by the device remotely connected to the
port.
Network Policies Specifies if network policy TLV is received in the LLDP frames on this port.
Media Policy Application Type: Specifies the application type. Types of application types are
unknown, voicesignaling, guestvoice, guestvoicesignalling, softphonevoice, videoconferencing,
streammingvideo, vidoesignalling. Each application type that is received has the VLAN id,
priority, DSCP, tagged bit status and unknown bit status. A port may receive one or many such
application types. If a network policy TLV has been receive on this port only then would this
information be displayed.
Vlan ID: Specifies the VLAN id associated with a particular policy type.
Priority: Specifies the priority associated with a particular policy type.
DSCP: Specifies the DSCP associated with a particular policy type.
Unknown: Specifies the unknown bit associated with a particular policy type.
Tagged: Specifies the tagged bit associated with a particular policy type.
Inventory Specifies if inventory TLV is received in LLDP frames on this port.
Hardware Rev: Specifies hardware version of the remote device.
To Next Page
Loading...
Need help?
General