_____________________________________________________________________________
LB9 User’s Guide 519/1523
6.16.7.3 ping ipv6 interface
This command use to determine whether another computer is on the network. To use the command,
configure the switch for network (in-band) connection. The source and target devices must have the ping
utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation with
which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path
between the switch and the workstation. The terminal interface sends three pings to the target station.
Use the interface keyword to ping an interface by using the link-local address. You can use a loopback,
tunnel, or logical interface as the source. Use the optional size keyword to specify the size of the ping
packet.
ping ipv6 interface {<slot/port> | serviceport | switchport | tunnel <tunnel-id>} | loopback <loopback-id>}
{<link-local-address>} [size <datagram-size>]
<slot/port> - Specify the interface.
<tunnel-id > - Specify the Tunnel ID. Range 0 -7.
<loopback-id > - Specify loopback Interface ID. Range 0 -7.
<link-local-address> - Specify link-local address.
<ipv6-address> - Specify the IPv6 address of the device.
<datagram-size> - Datagram size. Range 48 - 2048.
Default Setting
None
Command Mode
Privileged Exec
To Next Page
Loading...