_____________________________________________________________________________
LB9 User’s Guide 561/1523
6.19.1.3 show ip arp inspection interfaces
This command displays the Dynamic ARP Inspection configuration on all the DAI-enabled interfaces. An
interface is said to be enabled for DAI if at least one VLAN, that the interface is a member of, is enabled
for DAI. Given a slot/port interface argument, the command displays the values for that interface whether
the interface is enabled for DAI or not.
<slot/port> - Interface Number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: The interface ID for each displayed row.
Trust State: Whether the interface is trusted or untrusted for DAI.
Rate Limit: The configured rate limit value in packets per second.
Burst Interval: The configured burst interval value in seconds.
To Next Page
Loading...