To Next Page

To Previous Page

UANTA COMPUTER INC.

Layer 2/3/4 Managed Switch

_____________________________________________________________________________

LB9 User’s Guide 599/1523

6.20.3.14 police-two-rate

This command is the two-rate form of the police command and is used to establish the traffic policing

style for the specified class. For each outcome, the only possible actions are drop, set-cos-as-sec-cos,

set-cos-transmit, set-sec-cos-transmit, set-dscp-transmit, set-prec-transmit, or transmit. In this two-rate

form of the police command, the conform action defaults to send, the exceed action defaults to drop, and

the violate action defaults to drop. These actions can be set with this command once the style has been

configured.

Syntax

police-two-rate {1-4294967295 1-4294967295 1-128 1-128 conform-action {drop | set-

cos-as-sec-cos | set-cos-transmit 0-7 | set-sec-cos-transmit 0-7 | set-prec-

transmit 0-7 | set-dscp-transmit 0-63 | transmit} exceed-action {drop | set-cos-

as-sec-cos | set-cos-transmit 0-7 | set-sec-cos-transmit 0-7 | set-prec-transmit

0-7 | set-dscp-transmit 0-63 | transmit} [violate-action {drop | set-cos-as-sec-

cos | set-cos-transmit 0-7 | set-sec-cos-transmit 0-7 | set-prec-transmit 0-7 |

set-dscp-transmit 0-63 | transmit}]}

<conform-action & violate-action & exceed-action > - The conforming data rate is specified in

kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is

specified in kilobytes (KB) and is an integer from 1 to 128. For each outcome, the only possible

actions are drop, set-dscp-transmit, set-prec-transmit, or set-cos-transmit. In this simple form of the

police command, the conform action defaults to transmit and the violate action defaults to drop.

These actions can be set with this command once the style has been configured. Beside, the

set-cos-transmit is to combine only with drop between the conform-action and the violate-action.

<set-cos-transmit> - an priority value is required and is specified as an integer from 0-7.

<set-dscp-transmit> - is required and is specified as either an integer from 0 to 63, or symbolically

through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,

af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.

<set-prec-transmit> - an IP Precedence value is required and is specified as an integer from 0-7.

Command Mode

Policy-Class-Map Config

Quanta Computer T5016-LB8D User Manual

Questions and Answers: