Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 798/1523
8.2.2.4 ip igmp last-member-query-interval
This command configures the Maximum Response Time being inserted into Group-Specific Queries
sent in response to Leave Group messages on the interface.
ip igmp last-member-query-interval <0-255>
no ip igmp last-member-query-interval
<0-255> - The range for <0-255> is 0 to 255 tenths of a second.
no - This command resets the Maximum Response Time being inserted into Group-Specific Queries
sent in response to Leave Group messages on the interface to the default value.
Default Setting
10 tenths of a second
Command Mode
Interface Config
8.2.2.5 ip igmp query-interval
This command configures the query interval for the specified interface. This is the frequency at which
IGMP Host-Query packets are transmitted on this interface.
ip igmp query-interval <1-3600>
no ip igmp query-interval
<1-3600> - The range for <1-3600> is 1 to 3600 seconds.
no - This command resets the query interval for the specified interface to the default value. This is
the frequency at which IGMP Host-Query packets are transmitted on this interface.
Default Setting
125 seconds
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General