Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 799/1523
8.2.2.6 ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface.The time interval is
specified in tenths of a second.
ip igmp query-max-response-time <0-255>
no ip igmp query-max-response-time
<0-255> - The range for <0-255> is 0 to 255 tenths of a second.
no - This command resets the maximum response time interval for the specified interface, which is
the maximum query response time advertised in IGMPv2 queries on this interface to the default
value. The maximum response time interval is reset to the default time.
Default Setting
100
Command Mode
Interface Config
8.2.2.7 ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is the tuning
for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss, the Robustness
variable may be increased for the interface.
ip igmp robustness <1-255>
no ip igmp robustness
<1-255> - The range for <1-255> is 1 to 255.
no - This command sets the robustness value to default.
Default Setting
2
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General