Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 816/1523
8.4.2.2 ip mcast boundary
This command adds an administrative scope multicast boundary specified by <groupipaddr> and
<mask> for which this multicast administrative boundary is applicable. <groupipaddr> is a group IP
address and <mask> is a group IP mask.
ip mcast boundary <groupipaddr> <mask>
no ip mcast boundary <groupipaddr> <mask>
<groupipaddr> - the multicast group address for the start of the range of addresses to be excluded.
The address must be in the range of 239.0.0.0 through 239.255.255.255.
<mask> - mask to be applied to the multicast group address.
no - This command deletes an administrative scope multicast boundary specified by <groupipaddr>
and <mask> for which this multicast administrative boundary is applicable. <groupipaddr> is a group
IP address and <mask> is a group IP mask.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...