_____________________________________________________________________________
LB9 User’s Guide 820/1523
8.5.1.3 show ip pim interface
This command displays the interface information for PIM on the specified interface. If no interface is
specified, the command displays the status parameters for all PIM-enabled interfaces.
<slot/port> - Interface number.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Interface: slot/port
Mode: Indicates whether the PIM mode enabled on the interface is dense or sparse
Hello Interval: The frequency at which PIM hello messages are transmitted on this interface. By
default, the value is 30 seconds
Join Prune Interval: The join/prune interval for the PIM router. The interval is in seconds
DR Priority: The priority of the Designated Router configured on the interface. This field is not
applicable if the interface mode is Dense
BSR Border: Identifies whether this interface is configured as a bootstrap router border interface
Neighbor Count: The number of PIM neighbors learned on this interface. This is a dynamic value
and is shown only when a PIM interface is operational
Designated Router: The IP address of the elected Designated Router for this interface. This is a
dynamic value and will only be shown when a PIM interface is operational. This field is not applicable
if the interface mode is Dense
To Next Page
Loading...
Need help?
General