Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 821/1523
8.5.1.4 show ip pim neighbor
This command displays PIM neighbors discovered by PIMv2 Hello messages. If the interface number is
not specified, this command displays the neighbors discovered on all the PIM enabled interfaces.
show ip pim neighbor [{<slot/port> | vlan <vlan-id>}]
<slot/port > - Interface number.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Neighbor Address: The IP address of the neighbor on an interface
Interface: slot/port
Up Time: The time since this neighbor has become active on this interface
Expiry Time: The expiry time of the neighbor on this interface
DR Priority: The DR Priority configured on this Interface (PIM-SM only)
DR Priority is applicable only when sparse-mode configured routers areneighbors.
Otherwise, NA is displayed in this field
To Next Page
Loading...
Need help?
General