Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 825/1523
8.5.2.2 ip pim dense
This command enables the administrative mode of PIM-DM in the router.
ip pim dense
no ip pim dense
no - This command disables the administrative mode of PIM-DM in the router.
Default Setting
Disabled
Command Mode
Global Config
8.5.2.3 ip pim rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter rp-address is the IP address of the RP. The parameter groupaddress is the group address
supported by the RP. The parameter groupmask is the group mask for the group address. The optional
keyword override indicates that if there is a conflict, the RP configured with this command prevails over
the RP learned by BSR.
ip pim rp-address rp-address group-address/prefix-length [override]
no ip pim rp-address rp-address group-address/prefix-length
no - This command is used to statically remove the RP address for one or more multicast groups.
Default Setting
0
Command Mode
Global Config
This command takes effect only when PIM-SM is configured as the PIM mode
To Next Page
Loading...
Need help?
General