Quanta Computer T5016-LB8D - Page 826

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 826/1523
8.5.2.4 ip pim rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR).
Syntax
ip pim rp-candidate interface {<slot/port> | vlan <vlan-id>} <group-address> <group-mask>
no ip pim rp-candidate interface {<slot/port> | vlan <vlan-id>} <group-address> <group-mask>
<slot/port> - Valid slot and port number separated by forward slashes.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
<group-address> - Specifies the group address.
<group-mask> - Specifies the group mask.
no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default Setting
None
Command Mode
Global Config
i
This command takes effect only when PIM-SM is configured as the PIM mode
8.5.2.5 ip pim sparse
This command enables the administrative mode of PIM-SM in the router.
Syntax
ip pim sparse
no ip pim sparse
no - This command disables the administrative mode of PIM-SM in the router.
Default Setting
Disabled
Command Mode
Global Config