Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 827/1523
8.5.2.6 ip pim spt-threshold
Use this command to configure the Data Threshold rate for the last-hop router to switch to the shortest
path. The possible values are 0 or Infinity.
ip pim spt-threshold {0 | Infinity}
no ip pim spt-threshold
no - This command is used to set the Data Threshold rate for the RP router to the default value.
Default Setting
0
Command Mode
Global Config
This command takes effect only when PIM-SM is configured as the PIM mode
8.5.2.7 ip pim ssm
Use this command to define the Source Specific Multicast (SSM) range of IP multicast addresses.
ip pim ssm {default | <group-address> <group-mask>}
no ip pim ssm {default | <group-address> <group-mask>}
<group-address> - Specifies the group address.
<group-mask> - Specifies the group-mask.
no - This command is used to disable the specified Source Specific Multicast (SSM) range.
Default Setting
Disabled
Command Mode
Global Config
Parameters
default - Defines the SSM range access list to 232/8.
To Next Page
Loading...
Need help?
General