Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 829/1523
8.5.2.10 ip pim dr-priority
Use this command to set the priority value for which a router is elected as the designated router (DR).
This command can be configured on a single interface or a range of interfaces.
ip pim dr-priority <0-2147483647>
no ip pim dr-priority
no - Use this command to reset the priority value for which a router is elected as the designated
router (DR).
Default Setting
1
Command Mode
Interface Config
This command takes effect only when PIM-SM is configured as the PIM mode
8.5.2.11 ip pim hello-interval
Use this command to configure the PIM hello interval for the specified router interface or range of
interfaces. The hello-interval is specified in seconds and is in the range 10–18000.
ip pim hello-interval <10–18000>
no ip pim hello-interval
no - Use this command to set the PIM hello interval to the default value.
Default Setting
30
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General