_____________________________________________________________________________
LB9 User’s Guide 833/1523
8.6.1.3 show ipv6 pim interface
Use this command to displays the interface information for PIM on the specified interface. If no interface
is specified, the command displays the status parameters for all PIM-enabled interfaces.
<slot/port> - Valid slot and port number separated by forward slashes.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Interface: slot/port.
Mode: Indicate whether the PIM mode enabled on the interface is dense or sparse.
Hello Interval: The frequency at which PIM hello messages are transmitted on this interface. By
default, the value is 30 seconds.
Join Prune Interval: The join/prune interval for the PIM router. The interval is in seconds. By
default, the value is 60 seconds.
DR Priority: The priority of the Designated Router configured on the interface. This field is not
applicable if the interface mode is Dense.
BSR Border: Identifies whether this interface is configured as a bootstrap router border interface.
Neighbor Count: The number of PIM neighbors learned on this interface. This is a dynamic value
and is shown only when a PIM interface is operational.
Designated Router: The IP address of the elected Designated Router for this interface. This is a
dynamic value and will only be shown when a PIM interface is operational. This field is not applicable
if the interface mode is Dense.
To Next Page
Loading...
Need help?
General