Quanta Computer T5016-LB8D - Page 834

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 834/1523
8.6.1.4 show ipv6 pim neighbor
Use this command to display PIM neighbors discovered by PIMv2 Hello messages. If the interface
number is not specified, this command displays the neighbors discovered on all the PIM-enabled
interfaces.
Syntax
show ipv6 pim neighbor [{<slot/port> | vlan <vlan-id>}]
<slot/port> - Valid slot and port number separated by forward slashes.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Interface: Slot, and port number separated by forward slashes.
Neighbor Address: The IP address of the neighbor on an interface.
Up Time: The time since this neighbor has become active on this interface.
Expiry Time: The expiry time of the neighbor on this interface.
DR Priority: The DR Priority configured on this interface (PIM-SM only).