_____________________________________________________________________________
LB9 User’s Guide 870/1523
ï‚· Hours:Minutes:Seconds if days < 1
Interface: The outgoing router interface to use when forwarding traffic to the next destnation.
To administratively control the traffic destined to a particular network and prevent it from being forwarded
through the router, you can configure a static reject route on the router. Such traffic would be discarded
and the ICMP destination unreachable message is sent back to the source. This is typically used for
preventing routing loops. The reject route added in the RTO is of the type OSPF Inter-Area. Reject
routes (routes of REJECT type installed by any protocol) are not redistributed by OSPF/RIP. Reject
routes are supported in both OSPFv2 and OSPFv3.
9.3.1.6 show ipv6 route preferences
This command displays the preference value associated with the type of route. Lower numbers have a
greater preference. A route with a preference of 255 cannot be used to forward traffic.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Local: Preference of directly-connected routes.
Static: Preference of static routes.
OSPF Intra: Preference of routes within the OSPF area.
OSPF Inter: Preference of routes to other OSPF routes that are outside of the area.
OSPF External: Preference of OSPF external routes.
RIPng: Preference of RIPng routes.
To Next Page
Loading...
Need help?
General