Spectrum Measurements
R&S
®
ESR
384User Manual 1175.7068.02 ─ 12
Video Output............................................................................................................... 384
Trigger Out.................................................................................................................. 384
Probe Config............................................................................................................... 384
Input (AC/DC)
Toggles the RF input of the R&S ESR between AC and DC coupling.
Remote command:
INPut:COUPling on page 672
Preselector (On Off)
Turns the preselector on and off.
Remote command:
INPut:PRESelection:STATe on page 931
Noise Source
Switches the supply voltage for an external noise source on or off.
For details on connectors refer to "NOISE SOURCE CONTROL" on page 33.
Remote command:
DIAGnostic<n>:SERVice:NSOurce on page 931
Video Output
Selects the type of output for the optional IF / Video output.
When you turn on the output, you can select to output either the intermediate fre-
quency or the video signal.
Note: Video output does not return valid values in IQ or FFT mode.
Remote command:
OUTP:IF VID , see OUTPut:IF[:SOURce] on page 932
Trigger Out
Sets the Trigger Out port to low or high. Thus, you can trigger an additional device via
the external trigger port, for example.
Remote command:
OUTPut:TRIGger on page 932
Probe Config
Opens an edit dialog box to activate and configure a connected probe which is to pro-
vide an input signal. It is only available if a probe is connected to the instrument's [RF
Input] and USB connectors.
For details see Chapter 6.2.9.2, "Using Active Probes for Input", on page 385.
Remote command:
PROBe[:STATe] on page 822
PROBe:SETup:MODE on page 821
Configuration
To Next Page
Loading...
Need help?
General
