R&S ESR Series

Spectrum Measurements
R&S
®
ESR
392User Manual 1175.7068.02 ─ 12
Auto Peak ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Auto Peak" detector.
The "Auto Peak" detector determines the maximum and minimum value within a mea-
surement point. The Auto Peak detector is not available for SEM measurements.
Remote command:
DET APE, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
Positive Peak ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Positive Peak" detector.
Remote command:
DET POS, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
Negative Peak ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Negative Peak" detector.
Remote command:
DET NEG, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
Sample ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Sample" detector.
Remote command:
DET SAMP, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
RMS ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "RMS" detector.
Remote command:
DET RMS, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
Average ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Average" detector.
Remote command:
DET AVER, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
Quasipeak ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "Quasipeak" detector.
Remote command:
DET QPE, see [SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 853
CISPR Average ← Detector ← Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the "CISPR Average" detector.
Analysis