R&S ESR Series

Remote Control
R&S
®
ESR
638User Manual 1175.7068.02 ─ 12
DISPlay:BARGraph:PHOLd:RESet.................................................................................. 638
DISPlay:BARGraph:TCOupling[:STATe]............................................................................638
[SENSe:]DETector:RECeiver[:FUNCtion]..........................................................................639
[SENSe:]SWEep:TIME................................................................................................... 639
DISPlay:BARGraph:LEVel:LOWer?
This command queries the minimum level of the bargraph.
Example:
:DISP:BARG:LEV:LOW?
Usage: Query only
DISPlay:BARGraph:LEVel:UPPer?
This command queries the maximum level of the bargraph.
Example:
:DISP:BARG:LEV:UPP?
Usage: Query only
DISPlay:BARGraph:PHOLd[:STATe] <State>
This command switches the indication of the maxhold value of the bar graph measure-
ment on or off.
Parameters:
<State> ON
OFF
*RST: OFF
Example:
DISP:BARG:PHOL ON
Manual operation: See "Bargraph Maxhold" on page 158
DISPlay:BARGraph:PHOLd:RESet
This command resets the maxhold value of the numeric indication of the bargraph
measurement.
Example:
:DISP:BARG:PHOL:RES
Usage: Event
Manual operation: See "Maxhold Reset" on page 158
DISPlay:BARGraph:TCOupling[:STATe] <State>
This command couples or decouples the bargraph detector and scan trace detector.
Parameters:
<State> ON | OFF
*RST: OFF
Remote Commands in Receiver Mode