R&S ESR Series

Remote Control
R&S
®
ESR
716User Manual 1175.7068.02 ─ 12
Compared to shifting the limit line, an offset does not actually change the limit line defi-
nition points.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<Offset> Numeric value that defines the offset.
*RST: 0
Example:
CALC:LIM2:UPP:OFFS 3dB
Shifts limit line 2 by 3 dB upwards.
Manual operation: See "Y Offset" on page 212
CALCulate<n>:LIMit<k>:UPPer:SHIFt <Value>
This command moves a complete upper limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<Distance> Numeric value that defines the distance of the shift.
The unit depends on CALCulate<n>:LIMit<k>:UNIT
on page 708.
Example:
CALC:LIM3:UPP:SHIF 20
Shifts all Y values of limit line 3 by 20 limit line units, e.g. dB.
Usage: Event
CALCulate<n>:LIMit<k>:UPPer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the upper limit line.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<InterpolType> LINear | LOGarithmic
*RST: LIN
Example:
CALC:LIM:UPP:SPAC LIN
Remote Commands in Receiver Mode