R&S ESR Series User Manual

Remote Control
R&S
®
ESR
730User Manual 1175.7068.02 ─ 12
[SENSe:]POWer:ACHannel:NAME:CHANnel<channel>.....................................................732
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]............................................................. 732
[SENSe:]POWer:ACHannel:SPACing:ALTernate<channel>................................................ 733
[SENSe:]POWer:ACHannel:SPACing:CHANnel<channel>................................................. 733
[SENSe:]POWer:ACHannel:TXCHannel:COUNt................................................................733
[SENSe:]POWer:ACHannel:ACPairs <ChannelPairs>
This command sets the number of adjacent channels (upper and lower channel in
pairs).The figure 0 stands for pure channel power measurement.
Parameters:
<ChannelPairs> 0 to 12
*RST: 1
Example:
POW:ACH:ACP 3
Sets the number of adjacent channels to 3, i.e. the adjacent
channel and alternate adjacent channels 1 and 2 are switched
on.
Manual operation: See "# of Adj Chan" on page 237
See "Channel Bandwidth " on page 251
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ACHannel <Bandwidth>
This command defines the channel bandwidth of the adjacent channel of the radio
transmission system. If the bandwidth of the adjacent channel is changed, the band-
widths of all alternate adjacent channels are automatically set to the same value.
With [SENSe<source>:]POWer:HSPeed set to ON, steep-edged channel filters are
available. For further information on filters refer to Chapter 6.2.6.4, "List of Available
RRC and Channel Filters", on page 367 .
Parameters:
<Bandwidth> 100 Hz to 40 GHz
*RST: 14 kHz
Example:
POW:ACH:BWID:ACH 30 kHz
Sets the bandwidth of all adjacent channels to 30 kHz.
Manual operation: See "Bandwidth" on page 238
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ALTernate<channel>
<Bandwidth>
This command defines the channel bandwidth of the specified alternate adjacent chan-
nels of the radio transmission system. If the channel bandwidth of one alternate adja-
cent channel is changed (e.g. channel 3), the bandwidth of all subsequent alternate
adjacent channels (e.g. 4–11) is automatically set to the same value.
Remote Commands in Spectrum Analyzer Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English